Crossover Adjustment (X-Over) - Fujitsu ECLIPSE CD8455 Owner's Manual

High-power "pro customize" cd/ms receiver with mp3/wma decoder and remote
Table of Contents

Advertisement

How to operate the Sound Adjustment Mode

Crossover adjustment (X-Over)

The frequencies for the front and rear speaker high-pass filter (HPF)
and woofer low-pass filter (LPF) can be set within a range of 63 to
200 Hz. (This is the same as the HPF and LPF cutoff frequencies.)
If no woofer has been connected, set the slope adjustment to "PASS".
(If slope is set to a setting other than PASS, the low frequency range
will not be output from the speakers.)
Turn the [SEL] button to select X-Over.
The selected item will be highlighted.
Press the [SEL] button.
The mode will change to crossover setting mode.
Turn the [SEL] button to select the cut-off frequency.
When the button is turned, the frequency changes in the
following order.
↔ 80Hz ↔ 100Hz ↔ 125Hz ↔ 160Hz ↔ 200Hz ↔
63Hz
Press the [
] or [
[ ] button :
The slope becomes more gentle.
[ ] button :
The slope becomes steeper.
The slope can be set to "PASS", "6dB/oct", "12dB/oct", "18dB/
oct" or "24dB/oct".
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] or [RTN] button to exit sound
adjustment mode.
[SOUND] button
[SEL] button [ ] button
] buttons to set the slope.
142
[RTN] button
[ ] button

Advertisement

Table of Contents
loading

Table of Contents