Fujitsu ECLIPSE CD8443 Owner's Manual page 75

4 Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
Press the [SOUND] button for less than one second to
5
exit sound adjustment mode.
The initial EQ settings are factory preset.
ATTENTION
Fine-tuning EQ functions
Fine adjustments can be made in each equalizer mode.
1
Select the equalizer mode.
Refer to the section "Switching equalizer modes" on page
74.
2
Turn the [SEL] button to select the frequency to be
adjusted.
When the button is turned, the frequency changes in the
following order.
63Hz ↔ 100Hz ↔ 160Hz ↔ 250Hz ↔ 400Hz ↔ 630Hz ↔
1kHz ↔ 1.6kHz ↔ 2.5kHz ↔ 4kHz ↔ 6.3kHz ↔ 10kHz ↔
16kHz
3 Press the [SEEK
This adjusts the frequency level.
[SEEK ] button: Increases level.
[FAST ] button: Decreases level.
Hold down a button, [1] to [5], for more than two
4
seconds to preset a value.
The preset value is overwritten by the value set using the
above steps.
5
Press the [RTN] button.
At this time, other adjustments can also be made in normal
mode.
6
Press the [SOUND] button for less than one second to
exit sound adjustment mode.
How to operate the Sound Adjustment Mode
Buttons [1] to [5]
/FAST ] button.
75
[SOUND] button
[SEEK ] button
[SEL]
button
[RTN] button
[FAST ] button