Separate all accessories.
Power cycle the printer.
The formatter PCA is defective.
The DC controller is defective.
The power supply is defective.
02 Warming Up (if 3 Minutes)—See also
The Input/Output (I/O) cable is hooked up incorrectly or there is bad
I/O in the computer.
– Remove the I/O cables and power cycle the printer.
There are defective component(s).
– Replace the fusing assembly if it is not warming up the DC
controller, PCA power supply, or formatter PCA.
The display cable or formatter PCA is defective.
The I/O cable is hooked up incorrectly or there is bad I/O in the
– Remove the I/O cables. Replace the formatter PCA.
The DC power supply/main motor drive is defective.
22 – Control panel messages