Prior to the new executive tray, Tray 1 was the only source for printing
this size of media. The executive tray replaces the standard Tray 2. All
other sizes must feed from either Tray 1 or Tray 3.
"X" in the fourth position of the serial number. Response Center
systems have been updated to recognize the Executive printer for repair
purposes because the Executive printer has three unique parts:
• DC controller, part number C3166-60153
• Executive-size tray, part number R77-0008-000CN
• Printer label, C3166-00032
Become familiar with these two specific conditions:
1 If you receive the message "MANUALLY FEED TRAY 1 PLAIN
EXECUTIVE", when Tray 2 is empty, load executive-size paper into
Tray 2 and press [Select] on the printer control panel.
2 If Tray 1 and Tray 2 are loaded with different types of executive-size
paper, such as plain executive paper in Tray 1 and yellow executive
paper in Tray 2, you must select your input tray by media type, rather
than by the input tray. See the user guide for information on
configuring the media types at the control panel for each tray. Make
the type selection in the printer driver on the PAPER tab, which is
under the OPTIONS button for the printer, or from the Page Setup
dialog of the word processing application.
The Executive printer is identified with an
Technical Tips – 229