4.1 OVERVIEW
This section describes procedures for adjustments which required when the printer is
disassembled and assembled for repair.
T T
Once the ink cartridge is removed from the printer before ink-end, never re-use it.
T T
For adjustment and testing, always replace the ink cartridge to new one designed
exclusively for service:
Description:
Code:
4.1.1 Adjustment Tools
The table below lists the tools required to make adjustment on EPSON Stylus Color 300.
Tool
Thickness Gauge Set #F518
*1
Adjustment Program
Name: CLR300.EXE
4.1.2 Applicable Repair
An appropriate adjustment have to be made according to the type of repair performed.
C224 MAIN board is replaced *1
Printhead is replaced *2
Printer mechanism is replaced *2
CR Motor or timing belt is replaced
Carriage assembly is disassembled
Note) *1:
Replace the ink cartridge and the waste ink pad to new one and reset
ink counter and protect counter.
*2:
Replace the ink cartridge to new one and reset initial charge flag and
ink counter.
Rev. A
Table 4-1. Tools for Adjustment
Code
B776702201
-----
Table 4-2. Applicable Adjustment
Repair
CAUTION
Applicable Adjustment
Platen Gap Adjustment
Head Angle Adjustment
Bi-D Adjustment
Zig-Zag Alignment Adjustment
RESET function for:
*Ink counter
*Initial charge flag
*Protect counter (Waste ink counter)
Applicable Adjustment
Zig-Zag Alignment Adjustment
Bi-D Adjustment
Zig-Zag Alignment Adjustment
Head Angle Adjustment
Zig-Zag Alignment Adjustment
Bi-D Adjustment
Bi-D Alignment
Chapter 4 Adjustment
4-1