Download Print this page

Advertisement

Table 30. Numeric error messages (continued)
Control panel
message
alternates with
alternates with
alternates with
alternates with
C8519-90912
Event log
Description
error
message
l
Scan buffer error.
l
A failure in an external input
device has occurred.
l
The retainer sensor never
activated.
l
The retainer DC motor, located
in the accumulator, is
damaged.
l
Device not able to finish
power-on sequence.
l
The bearing bracket is
damaged.
l
The accumulator wheel sensor
is damaged.
l
Device not able to finish
power-on sequence.
l
The offset module did not
reach the offset position.
l
The device firmware has
detected five consecutive
jams.
l
EEPROM error.
l
EEPROM on the controller
PCA is damaged.
Recommended action
l
Turn the printer off and back
on to continue.
l
Reseat connections to the
laser/scanner and DC
controller.
l
If error persists, replace the
laser/scanner.
l
Replace the DC controller.
l
Check connections.
l
Turn the printer off and back
on to continue.
l
Send two pages through for a
test job.
l
Reseat the input device.
l
Replace the input device.
l
Check cables.
l
Turn the printer off and back
on to continue.
l
Send two pages through for a
test job.
l
Replace the accumulator
assembly.
l
Replace the output device
controller PCA.
l
Check cables.
l
Turn the printer off and back
on to continue.
l
Send two pages through for a
test job.
l
Replace the accumulator
assembly.
l
Replace the output device
controller PCA.
l
Check cables.
l
Turn the printer off and back
on to continue.
l
Send two pages through for a
test job.
l
Replace the offset assembly.
l
Replace the output device
controller PCA.
l
Check cables.
l
Turn the printer off and back
on to continue.
l
Send two pages through for a
test job.
l
Replace the output device
controller PCA.
Control panel messages 235

Advertisement

Chapters

Troubleshooting

   Related Manuals for HP LaserJet 9000dn

Comments to this Manuals

Symbols: 0
Latest comments: