The fuser assembly can be hot. Use caution when removing it.
If an optional output accessory is installed, remove it. See page 171.
If a duplexer is installed, remove it. See page 146.
Lift the left door handle, and then open the left door.
Rotate the two blue locking tabs (callout 1) toward each other and downward to release them.
Do not release the T-shaped envelope levers (callout 2).
Removing the fuser assembly (1 of 2)
Pull the center handle (callout 3) to rotate the fuser assembly upward slightly, and then slide the
fuser assembly outward until it locks.
The fuser assembly is heavy. Grasp the blue handle firmly before attempting to lift the fuser assembly.
Firmly grasp the blue handle (callout 4), and lift the fuser assembly out of the printer.
Removing the fuser assembly (2 of 2)
Left assemblies 147