10.4 Mounting the sewing light (optional equipment)
6
7
CAUTION !
The power supply to the sewing light is not disconnected when the
main switch is turned off. Remember to pull out the mains plug before
making this connection.
2
1
The sewing light 1 will be mounted on the arm cover 2.
–
Screw off the arm cover 2.
–
Use a 4.5-mm Ø bit to drill the fastening holes 3.
–
Screw the retainer piece 5 using screw 4.
–
Put the sticker with the safety notice on the front of the main
switch 7.
–
Put the sewing light onto the retainer piece 5.
–
Unscrew the valve cap 6.
–
Route the sewing light's supply cable into the cut-out on the
machine arm.
–
Guide the the connection cable downwards through the opening in
the table plate.
–
Fasten the sewing light transformer under the table plate using
particle-board screws.
–
Plug in the connector for the transformer's power supply.
–
Put on the cover 2 and valve cap 6.
2
5
4
3
GB
27