Table of Contents
Advertisement
10. Mounting the Direct Drive
10.1 Mounting the motor and putting on the V-belt
10.2 Connecting the Hall sensor
7
6
24
1
–
Unscrew the handwheel 1.
–
Screw motor 3 onto the head using two screws 4 (M6 x 16) so that
it can be easily shifted.
–
Put on the V-belt 5.
–
Tighten the V-belt.
Press the motor 3 downwards and tighten both screws 4.
When the belt has the correct tension, you should be able to press
down with your finger in the middle of the belt 6 (without excessive
force) so that the belt moves about 10 mm down.
Caution: Risk of injury !
Turn the main switch off.
Connect the Hall sensor only with the sewing machine turned off.
–
Screw off the arm cover 7 and valve cap 6.
5
4
3
Advertisement
Table of Contents
