3.5
Completing the table plate for the MG 56-3 stand with FIR clutch motor
10
Top view of table plate
7
(5x25) 2x
8
7
(5x25) 2x
6
–
Turn over the table plate 8.
–
Screw on the sewing light transformer 1 (optional equipment).
–
Screw on the cable duct 3.
–
Screw on the drawer 4 together with its fixtures.
–
Screw on the main switch 5.
–
Screw on the power supply 6 (optional equipment).
–
Screw on flap trays 7 using two wood screws per tray.
–
Mount the clutch motor 2.
For this, screw the three hexagon bolts (M8 x 40) with washers into
the anchor nuts on the table plate.
The belt pulley 9 must point to the left when the table plate is
mounted.
–
Mount the electrical cable according to the instructions in
chapter 12.
(4x20) 2x
9
1
(4x20) 2x
2
3
(3,5x17) 2x
Marking for
stand
4
(3,5x17) 6x
5
,5x25) 2x
2