Control From The Pedals - Korg Trinity series Basic Manual

4. About the performance functions
For details on the function assigned to SW1 and SW2 for each of the factory preset programs and
combinations, refer to the separate Voice Name List booklet.
VALUE slider
You can use this slider as an alternate modulation source or effect dynamic modulation source
(controller) when a program number is selected in Program Play mode, or when a combination is
selected in Combination Play mode.

Control from the pedals

Assignable Foot Pedal
An effect can be applied by operating an assignable foot pedal (Korg EXP-2 or XVP-10) connected
to the rear panel PEDAL jack.
The function of the foot pedal can be set in Global mode P1 "1–1: Global Setup" ( Parameter
Guide, page 129). This setting allows the foot pedal to control volume, a parameter value, or
tempo (when in Sequencer mode) etc. Or you can assign the pedal to control alternate modulation
or effect dynamic modulation.
Assignable Foot Switch
An effect can be applied by operating an assignable foot switch (Korg PS-1 etc.) connected to the
rear panel SWITCH jack.
The function of the foot switch can be set in Global mode P1 "1–1: Global Setup" ( Parameter
Guide, page 129). This setting allows the connected foot switch to select programs or combina-
tions, to start/stop the sequencer, or to punch in/out when recording on the sequencer. Or you
can assign the switch to control alternate modulation or effect dynamic modulation.
18