Removing the CARRIAGE ASSY.
3.2.4.7
Remove the printer mechanism (see Section 3.2.4).
1.
Remove the BELT TENSION SPRING from the hook
2.
3.2.4.2), and remove the TIMING BELT of the CARRIAGE ASSY. from the PULLEY DRIVE.
3. Release the hook that attaches the SHEET,CABLE,HEAD to the FRAME,BASE. Slide the cable
to the left and remove it.
4. Remove the printhead FFC from the FRAME,BASE.
5. Remove the GROUNDING PLATESH~,CR from the left side of the printer mechanism.
6. Rotate both sides of the BUSH,PARALLEL ADJUST and remove them from the FRAME,LEFT
and RIGHT.
7. Remove the SHAFT ASSY.,CR GUIDE and the CARRIAGE ASSY.
GROUNDING
BUSH, PARALLEL
ADJUST
Figure 3-16. Removing the CARRIAGE ASSY.
\
CABLE HEAD
Disassembly and Assembly
on the
FRAME, RIGHT
3-15