System Set-Up; Set-Up Mode; Setup Screen (First); Brightness - Honda CR-V Navigation Manual

Set-up Mode

The Setup function consists of two
different screens that allow you to
change and update information in the
system. To display the Setup screens,
use the voice control system and say
"Setup," or press the SETUP button,
and then select an item, say or select
More in the upper right corner of the
screen.
On any of the Setup screens, you can
use the voice control system to select
any item on the screen.
NOTE:
• If some items appear to be grayed
out, and cannot be selected, it is
because you did not select OK on the
initial Disclaimer screen. See System
Start- up on page 16.
• For information on the available
voice commands, see Voice
Command Index on page 128.

Setup Screen (first)

From any screen, say "Setup" or press
the SETUP button and the following
screen appears:

Brightness

The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say "Brightness up"
or "Brightness down." You can also
select the Bright. bar and move the
cursor by pushing the joystick left or
right, or by touching the arrowhead in
the bar.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.

System Set-up

NOTE:
You can have a separate daytime and
nighttime setting for brightness. Adjust
each setting when the display is in
either daytime or nighttime mode.

Volume

The navi voice volume is adjustable in
10 steps, and also can be turned off. To
adjust the volume, use the voice control
system and say "Volume up" or
Volume down." You can also select the
"
Volume bar and move the cursor by
pushing the joystick left or right, or by
touching the arrowheads in the bar. After
adjusting the volume, you will hear
beeps at the new volume level. You can
also select volume off.
NOTE:
If you turn the volume off, you will not
hear route guidance or voice command
confirmations.
Navigation System 71