Eclipse AVN5435 Reference Manual page 4

Read the following prior
to using this device
• This device can be used when the engine switch is either at ON or ACC, how-
ever, to avoid depleting the battery, operate it with the engine running.
• This product must be operated only as on-board equipment, or it may cause
electrical shock or injury.
• Play the audio at a moderate volume level that permits you to hear sounds from
outside the car. Driving without being able to hear outside sounds may result in
an accident.
• Check the volume prior to turning the device ON. If the volume is turned up
when turning the switch ON, a loud sound will emit which may damage your
hearing.
• Do not put your fingers into the disc insert slot. Otherwise, injury may result.
• Exercise caution as to avoid getting your fingers caught when closing the dis-
play or adjusting its angle. Otherwise, injury may result.
• Do not touch heated parts of the device. Otherwise, burns may result.
• For safety reasons when moving the device, have a specialist at the store of
purchase reinstall it for you. Specialized techniques are necessary to uninstall
or install the device.
• Do not use the device in the event it emits a distorted sound or other such
abnormality. Otherwise, fires may result.
• The device's liquid crystal display is equipped with a fluorescent tube. Check
your local rules and regulations regarding its proper disposal.
• Using the device at extremely high or low temperatures may lead to improper
operation and malfunctions. Lower your windows in order to bring down the
temperature before using the device especially during the hot summer months.
• Letting water or metal objects go into the device or exposing it to strong
shocks may cause malfunctions. Exercise caution.
• Take note of the following when ejecting a disc or setting the display tilt position:
For vehicles with an automatic transmission
• When removing each disc, switch to Neutral in the event of interference when
in Park and proceed. (For a column automatic transmission, perform this
operation when in either Park or Neutral.) Prior to this operation, the parking
brake should be set and the foot brake should be properly depressed to pre-
vent the vehicle from moving which may cause damage to property and/or
injury.
• When setting the tilt, make sure there is no interference generated from your
hand or other obstructions when setting either in Park, Reverse or Neutral. (If
there is interference when in Drive, do not set the tilt.)
For vehicles with a manual transmission
• When removing each disc, if interference is generated when in 1st, 3rd, 5th
or
form this operation while driving. Prior to this operation, the parking brake
should be set and the foot brake should be properly depressed to prevent
the vehicle from moving which may cause damage to property and/or injury.
• When setting the tilt, make sure there is no interference generated from your
hand or other obstructions when either in 1st, 3rd, 5th or
(Do not set the tilt if there is interference.)
(Reverse) gear, switch to Neutral and proceed. However, do not per-
4
(Reverse) gear.