Sxfp - Fujitsu Siemens Computers pmn User Manual

Message lines
The message is only significant for external FC controllers. The abortion may have been
initiated either by the SAN host or CentricStor. <host> contains the 4 most significant bytes
of the host WWN. A data transfer (read/write) is generally aborted, and the user receives
an error message.
Response
The message can be ignored for the internal FC controllers because the SCSI target
interface is not used here for data transfers. If the message occurs for an external FC
controller, the service must be notified.
SXFC050 stgt<num>.XX: protocol <num> registered twice
ALERT
Meaning
A configuration error has been located (e.g. an inconsistent 'vtls.conf').
Response
Notify maintenance staff.
9.2.7 SXFP... (FibreChannel Driver)

SXFP033

A02-ICPB : FC5: RESET controller initiated
None
Meaning
After a hardware or firmware defect, an attempt is made to reset the module. Once this has
been completed, you can, in most cases, continue to work normally. IOs during the period
of the reset may be aborted with an error, however.
SXFP040 fcpal<n> (sadm<m>): cannot abort job on target <t> lun <l>
NONE
SXFP040 fcpal<n> (sadm<m>): will not abort job on target <t> lun <l> anymore! Use manual
BusReset!
NONE
Meaning
After a timeout (see previous message SXSB007 on
the command that was sent. The attempt fails (cannot abort). The second variant of the
message (will not abort) only occurs with tape devices and indicates that only a bus
reset will rectify the error.
Response
Check the device specified in the message (when <m> = 12 or 13 it is generally a RAID
system, when <m> = 14 or 15 a tape device). The bus reset is executed on the GUI (XTCC)
using the SCSI controller function Reset Controller.
454
Explanation of console messages
page 495) an attempt is made to stop
U41117-J-Z125-7-76