Operation And Important Riding Points; Starting The Engine - Yamaha WR250XZ(C Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

Read the Owner's Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
Failure to familiarize yourself with
the controls can lead to loss of con-
trol, which could cause an accident
or injury.
6
EAU15951
TIP
This model is equipped with:
G
a lean angle sensor to stop the en-
gine in case of a turnover. In this
EWA10271
case, the multi-function display in-
dicates error code 30, but this is
not a malfunction. Turn the key to
"OFF" and then to "ON" to clear the
error code. Failing to do so will pre-
vent the engine from starting even
though the engine will crank when
pushing the start switch.
G
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. In this case,
the multi-function display indicates
error code 70, but this is not a mal-
function. Push the start switch to
clear the error code and to restart
the engine.
EAU46632

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
G
G
1. Turn the key to "ON" and make
NOTICE
If a warning light does not come on
for a few seconds, and then go off,
see page 4-2 for the corresponding
warning light circuit check.
6-1
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
See page 4-19 for more informa-
tion.
sure that the engine stop switch is
set to " ".
The following warning
should come on for a few seconds,
then go off.
G
Fuel level warning light
G
Coolant temperature warning
light
G Engine trouble warning light
EAU45124
lights
ECA15483