Yamaha XV17ATMV(C) Road Star Owner's Manual page 35

load and thereby soften the sus-
pension, turn the adjusting nut in
direction (b).
1. Special wrench
NOTE:
The spring preload setting is deter-
mined by measuring distance A, shown
in the illustration. The shorter distance
A is, the lower the spring preload; the
longer distance A is, the higher the
spring preload.
INSTRUMENT AND CONTROL FUNCTIONS
1. Distance A
Spring preload:
Minimum (soft):
Distance A = 42.5 mm (1.67 in)
Standard:
XV17AV(C)/XV17AWV(C)/
XV17AMV(C)
Distance A = 42.5 mm (1.67 in)
XV17ATV(C)/XV17ATMV(C)
Distance A = 45.5 mm (1.79 in)
Maximum (hard):
Distance A = 51.5 mm (2.03 in)
3. Tighten the locknut to the specified
torque.
Tightening torque:
Locknut:
35 Nm (3.5 m·kgf, 25 ft·lbf)
3-15
CAUTION:
Always tighten the locknut against
the adjusting nut, and then tighten
the locknut to the specified torque.
WARNING
This shock absorber contains highly
pressurized nitrogen gas. For prop-
er handling, read and understand
the following information before
handling the shock absorber. The
manufacturer cannot be held re-
sponsible for property damage or
personal injury that may result from
improper handling.
G
Do not tamper with or attempt to
open the gas cylinder.
G
Do not subject the shock ab-
sorber to an open flame or other
high heat sources, otherwise it
may explode due to excessive
gas pressure.
G
Do not deform or damage the
gas cylinder in any way, as this
will result in poor damping per-
formance.
ECA10120
EWA10220
3