Electric Operation - Dometic RM24A Service Manual

Turn off the gas valve (C), its handle vi11 then be pointing avay from the back
1.
of the cabinet.
Turn the voltage change switch (A) to the required setting, then connect the
r e f r i g e r a t o r t o t' a appropriate voltage supply,
When the electrical supply cord is connected to a 110 volt A.C. supply, tne
voltage on the switch (A) should show llOV, when connected to the battery, the
voltage on the switch (A) should show 12V.
Turn the electric thermostat knob (E) to No. 4.
3.
HOW TO START THE REFRIGERATOR -
25.
26.
GAS OPERATION (Fig. 72)
1. To start the refrigerator turn the knob A to position "Casl(. Tne gas valve is
now opened and the electric circuits are disconnected.
Turn the gas thermostat knob C to setting 4.
2.
3. Pull the knob D of the flame failure safety device and after 5-10 seconds press
the button E to the piezo lighter. The pressing may have to be repeated. Through
the reflector F it can be observed that the burner is lit.
After the burner has been lit keep the knob D in pulled out position for another
4.
5 seconds. Then release the knob and check through the reflector
burner stays lit,
Note: After a replacement of the gas container or a,long shut-off period the
gas pipes are likely to be filled with air, In such a case the lighting
procedure has to be repeated until the air is pushed out of the pipes and
the gas has reached the burner.
27.
ELECTRIC OPERATION (Fig, 72)
Check that the attachment plug of the flexible cord is
1.
the main supply. The 12 volt connection is made at the
r e a r o f t h e r e f r i g e r a t o r .
Turn the knob A to "off" position, then press the knob
2.
d e s i r e d e l e c t r i c p o s i t i o n .
t h e
that
correctly connected co
marked terminals at the
in to bottom and turn to