Dometic RM24A Service Manual page 17

C A U T I O N : It is of great importance that the screwdriver is applied in front of
one of the plastic tongues which hold the inner panel and the door
front together.
Replace the sealing gasket round the inner panel and snap the inner panel and
3.
the door front together.
4. Mount the evaporator door and refit its retainer.
Fig. 25
REPLACEMENT OF EVAPORATOR DOOR ON RM46, RM47, RM66, RM67
Push the carrier (A) inwards by means of a blunt mandrel or pin (fig. 27) and
1.
remove the shutter.
2. Pry the spring housings (B fig. 27) away from the lining so that it snaps out
and turn the spring housings downwards 180' (fig. 28).
3. Mount the new shutter in close position first on one side, making sure that the
cross slots engage in the cross on the hinge plate (C fig. 27).
4. Press the carrier on the opposite side so that the hinge plate on the shutter
can be pushed over it.
5. Turn the spring housings round and up until the small tag (A fig. 28) snaps
into the slot in the lining.
Fig. 2 7
See that the crosses engage.
Fig. 28
17