Button Sewing - Brother NV10 Operation Manual

■ Changing the stitch width
Press the "+" or "–" side of the stitch width key to
adjust the stitch width.
b
a Stitch width key
b Stitch width
c Narrow
d Wide
Memo
● Before sewing buttonholes, check the stitch
length and width by sewing a trial
buttonhole on a scrap piece of fabric.
– +
a

Button sewing

Buttons can be sewn on with the sewing machine.
Buttons with 2 or with 4 holes can be attached.
a Measure the distance between the holes in the
button to be attached.
b Raise the presser foot lever, and then slide the
drop feed lever, located at the rear of the
machine on the base, to
seen from the rear of the machine).
a
a Drop feed lever (as seen from the rear of
the machine)
The feed dogs are lowered.
c Turn on the sewing machine.
d Select stitch .
e Attach button fitting foot "M".
• For details, refer to "Replacing the presser
foot" (page 31).
f Adjust the stitch width so that it is the same as
the distance between the holes in the button.
(to the left as
3
59