Brother NV10 Operation Manual page 27

GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
g Without passing the thread through the
needle bar thread guide, manually thread the
right needle.
Pass the thread through the eye of the needle
from the front to the back.
h Attach zigzag foot "J".
• For details on changing the presser foot, refer
to "Replacing the presser foot" (page 31).
CAUTION
● When using the twin needle, be sure to attach
zigzag foot "J", otherwise the needle may
break or the machine may be damaged.
i Turn on the sewing machine.
The LCD comes on.
j
Select a stitch.
• For details on selecting a stitch, refer to
"Selecting a stitch" (page 40).
• For details on the stitches that can be sewn
with the twin needle, refer to "Stitch
Settings" (page 79).
26
k Start sewing.
• For details on starting to sew, refer to
"Starting to sew" (page 42).
Two lines of stitching are sewn parallel
to each other.
Note
● When using the twin needle, the stitches
may become bunched together, depending
on the types of thread and fabric that are
used. If this occurs, increase the stitch
length. For details on adjusting the stitch
length, refer to "Adjusting the stitch length
and width" (page 40).
CAUTION
● When changing the sewing direction, press
(needle position button) to raise the
needle from the fabric, and then raise the
presser foot lever and turn the fabric.
Otherwise the needle may break or the
machine may be damaged.
● Do not try turning the fabric with the twin
needle left down in the fabric, otherwise the
needle may break or the machine may be
damaged.