Electrolux EW 880F Instruction Booklet page 13

7. Start the programme
To start the selected programme, press the
Start/Pause button; the corresponding light stops
flashing.
The "Function"and "Door" lights illuminate.
The machine starts operating.
8. Altering a programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial to O
and then you can select the new programme.
The washing water remains in the tub.
Start the new programme by depressing the
Start/Pause button.
9. Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the button again to restart the
programme.
10. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
11. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
Start/Pause button.
The door can be opened when the "Door" light has
gone out.
If the "Door" light does not go out and the door
does not open, this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to "O". After about 3
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress
Start/Pause to restart it.
12. At the end of the programme
The machine stops automatically, the "End" pilot
light illuminates and the light of the Start/Pause
button goes out.
If the Rinse Hold option has been selected, the
"End" and "Door" phase lights are on to indicate that
the water must be emptied out before opening the
door.
To do this first turn the programme selector dial to "O"
and then to drain programme
. The spin programme is
performed at the maximum speed. In order to avoid
any creasing or damage in synthetic, delicate, hand
wash and wool items, the spin speed must be
reduced by means of the relevant button.
The door can only be opened after the Door light
has gone out.
Release of the lock is also indicated by the coming
on of the End light.
At the end of the programme turn the programme
selector dial to "O" to switch the machine off.
Remove the laundry from the drum and carefully
check that the drum is empty.
If you do not intend to carry out another wash, close
the water tap. Leave the door open to prevent the
formation of mildew and unpleasant smells.
13
or spin programme