AEG Electrolux LAVAMAT LAVALOGIC 1620 User Information page 30

Problem
Washing has not been
spun.
Water is leaking out
from under the
washing machine.
Softener was not
washed in. w
compartment for
conditioners is filled
with water.
Washing is heavily
creased.
The door cannot be
opened when the
appliance is switched
v
on. The
appears in the display.
The display goes out
while a wash cycle is
running.
The background
illumination of the
display has gone out
even though the
appliance is switched
on.
30
Only a few large items of
washing in the drum.
The screw connection on the
inlet hose is leaking.
The drainage hose is leaking. Replace drain hose.
The drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is
leaking.
The conditioner insert is not
correctly set into the
additive compartment or is
blocked.
There may have been too
much washing in the
machine.
The door is locked for safety
reasons.
symbol
Power cut.
For safety reasons, the door
will remain locked for
approx. 4 minutes.
The washing machine is in
stand-by mode.
Possible cause Remedy
Always load the drum as full
as possible. Mix large and
small items.
Screw the inlet hose in
firmly.
Close the cover properly.
Load washing carefully for
the next wash.
Close off emergency drain
hose properly.
Clean the detergent
dispenser drawer, insert the
conditioner insert firmly.
Observe maximum loads.
Wait until the O symbol
appears.
The programme will continue
when the power cut is over.
To remove washing:
If water can be seen in the
appliance, before opening
the door, first perform an
emergency drain.
Press any key.