Main Memory; Video Memory - HP Kayak XA-s 02xx Handbook

HP Kayak XA-s DT Series 02xx PC Workstation

Main Memory

The PC Workstation has three DIMM slots on the system board for installing
main memory. Models are supplied with 64 MB or 128 MB of main memory.
Memory upgrades are available in single 32 MB 64 MB, 128 MB and 256 MB ECC
unbuffered or non-ECC SDRAM modules.
Memory can be upgraded to a maximum of 768 MB using multiples of
(3 x 256 MB) of unbuffered or non-ECC SDRAM memory modules.
A serial EEPROM on each DIMM contains data on the memory speed. This
information is read at each power on, and access time settings are set
accordingly.

Video Memory

The graphics controller installed on the PC Workstation could be either a
Matrox Productiva G100, a Matrox Millennium G200 or a Matrox Productiva
G100-Quad.
The Matrox Productiva G100 has a total of 8 MB of video memory already
supplied on the graphics controller board which cannot be upgraded.
The Matrox Millennium G200 has a 8 MB of SGRAM memory already supplied
on the graphics controller board. Memory may be upgraded to a maximum of 16
MB by installing a 8 MB SGRAM memory module of onto the board.
The Matrox Productiva G100-Quad graphics card can support a multi-monitor
environment allowing for a custom-configured display solution of up to four
monitors at a time with a total of 16 MB of video memory (4 MB per monitor).
There are three possible configurations: horizontally, vertically, or in a square.
7
For the above mentioned graphics controllers, no switch or jumper settings
need to be changed (all jumpers should be left in the positions in which they
were set by the manufacturer).
Medium-Profile HP Kayak XA-s DT Series 02xx PC
Desktop Workstation 7-11
PC Workstations