Changing A Switch Setting On The System Board; Solving Audio Problems - HP Kayak XA-s 02xx Manual

Hp kayak xa-s, familiarization guide for minitower models

Hide thumbs Also See for Kayak XA-s 02xx:

Table of Contents

NOTE

Changing a Switch Setting on the

System Board

I have enabled switch 10 to activate the BootBlock recovery

process, but it doesn't work. Is this the correct switch to change?

Yes, it is the correct switch. Check that the switch has been

correctly set, and that your boot diskette is correctly config-

ured. Refer to the Kayak service handbook for details.

When changing a switch setting to the "down" position on the system board

switch bank, you must push the slide switch completely across. If the switch

stops in the middle, there is no change to the configuration.

Switch 10 also enables the HP MaxiLife firmware 'crisis' block if the power

cord is unplugged. In this case, the LCD status panel is not available and the

screen stays blank.

What do I do if I encounter any audio problems.

The volume level on the HP Kayak Workstation PCs is con-

trolled by the Mute and Volume keys through the HP

Enhanced Keyboard. First, check if the Mute key has not been

muted by mistake, If it has, press it to restore the audio

functions.

If this does not solve the problem, refer to the guide Using Sound,

preloaded on the PC Workstation for details on how to test and solve any

problems with audio features.

Changing a Switch Setting on the System Board

Table of Contents