After The Installation - Frigidaire FRS300ESC Installation Instructions Manual

30" ELECTRIC SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
To avoid breakage: Do NOT handle or manipulate
the unit by the cooktop glass.
1
The counter-top around the cut-out should be flat and leveled (see
hatched area on illustration 1).
2
Before installing the unit, measure the heights of the two (2) cabinet sides
(H1-4), front and back (see illustration 1) from the floor to the top of the
counter.
3
Level the range using the
four (4) leveling legs so
that the height from the
floor to the underside of
the cooktop glass frame
is greater than the tallest cabinet measurement
by at least 1/16" (see illustration 2).
4
Slide the unit into the cabinet. Make sure the center of the unit is aligned with the center
of the cabinet cut-out.
5
Remove the protective channels on each side of the glass cooktop
(if provided).
6
The metal flange under each side of the cooktop MUST be placed
over the cabinet countertop for proper unit support. The glass
cooktop should NOT directly touch the countertop (see illustration
2) or could cause glass breakage voiding the warranty. Level the
unit if needed.
7

After the installation,

MAKE SURE that the
unit is supported
by the leveling legs
NOT by the cooktop.
1 ½" Max.
Shave
(3.8 cm Max.)
Raised
Edge to
Clear
Space for a
31½" (81 cm)
Wide Cooktop.
3
H2
H1
H3
Illustration 1
Illustration 2
H4
To successfully install
the range, the initial
level height from
floor to underside
of cooktop glass
frame should be at
least 1/16" taller
than cabinet sides as
measured in step 1.