The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam.
The appliance can be installed to recirculate or extract contaminated air.
The hood can be switched on pushing directly onto the requested speed without ﬁ rstly having
to select 0/1 button.
Select the required fan speed and light if required.
In the recirculation mode the contaminated air enters the cooker hood through the grease ﬁ lters. The air is cleaned
by passing through the charcoal ﬁ lters before being passed back into the kitchen through the grilles in either side of
the chimney stack.
In the extraction mode the contaminated air enters the cooker hood passing through the grease ﬁ lters and is passed
out through the ducting into the atmosphere.
To obtain the best performance when cooking it is advisable to switch the cooker hood on for a few minutes before
you start cooking and leave it running for about 15 minutes after ﬁ nishing.
When used in the ducting mode the charcoal ﬁ lters are not required.
Never do ﬂ ambé cooking under this cooker hood.
Never leave frying pans unattended during use, as over-heated fats and oils can catch ﬁ re.
Do not leave naked ﬂ ames under the cooker hood.
Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood
Turns lighting on and off.
When pressed for about 1 seconds the motor is switched off.
Suitable for the strongest cooking vapours and odours. The function
becomes active when the button is pushed for about 2 seconds. After
10 minutes of functioning it turns off automatically. This function can be
interrupted by means of pressing any of the buttons.
Indicates that the Metal grease ﬁ lters saturation alarm has been triggered,
and the ﬁ lters need to be washed. The alarm is triggered after 100 working
hours. (Reset; check the Maintenance-paragraph)
indicates that the activated charcoal odour ﬁ lter saturation alarm has been
triggered, and the ﬁ lter has to be replaced; the metal grease ﬁ lters must
also be washed. The activated charcoal odour ﬁ lter is triggered after 200
working hours. (Activation and Reset; check the Maintenance-paragraph)