Programming The Oven - Zanussi ZBM 799 Operating Instructions Manual

PROGRAMMING THE OVEN

Figure 3 shows the keys, the pilot lights for all
thze functions and the programmer displays.
(1) Setting and displaying the minute
counter - Timer
(2) Setting and displaying the cooking
time - Timer
(3) Setting and displaying the end of
the cooking time
(4) Manual operation
(5) Setting the times - Increase
(6) Setting the times -Decrease
Indicator Lights for the Time
Functions
When the indicator lights are on the appliance is
operating, as follows.
(A) General operation
(B) Working programme
A
(C) Automatic
U
T
O
Setting the Timer
When the oven is installed and the power supply
is switched on, the display flashes and shows
0.00.
To set the time of day
Press keys (1) and (2) at the same, and set the
actual time, by pressing keys (-) and (+) within 4
seconds. The oven remains in manual operation
and can be used without any programming.
Important Information
• Between 22.00 hrs and 6.00 hrs the display
Fig. 3
intensity is automatically dimmed.
• If the acoustic signal is not disconnected (as
per subsequent instructions), it cuts off after 2
minutes.
• Any programming described below is active
ted after approximately 4 seconds from the
presetting.
• 23 hrs and 59 minutes is the maximum pro-
grammed time. Any and all programmed set-
tings are erased when there is a power cut or
supply failure. When power is restored the
display flashes and shows 0.00. To reset the
programmer set both the actual time and the
programme again.
Automatic Operation
The oven can be programmed to switch on and
off automatically.
To do this proceed as follows:
1. Select the required cooking function and tem-
perature using the function selector and the
thermostat dial.
2. Press key (2) and set the cooking time by
pressing keys (-) and (+) within the next 4
seconds
3. Press key (3) and set the end of the cooking ti-
me in the same way.
29