Maintenance And Care; Opening The Grille; Grease Filter; Carbon Filter - AEG 115 D Installation And Operating Instructions Manual

Electrolux operating instructions extractor hood 115 d
Table of Contents

Advertisement

Maintenance and care

The hood must always be disconnected from the mains power
supply before beginning any maintenance work.
Opening
— Open the latch L and swing the grille downwards. — Fig. 7.
the grille
— To remove the grille, pull it forwards from the right and release it.
L
M
7
The metal grease filter has been designed to absorb the grease

Grease filter

particles that are formed during cooking and is always used,
irrespective of whether the hood is set up for extractor or filter
operation.
The metal grease filter is positioned on the inside of its related
support grille.
Leave the metal grease filter panel to soak for approximately 1
hour in very hot water with grease-dissolving detergent and then
rinse it with very hot water. Repeat the operation if necessary.
Load the grease filter panel in a dishwasher, selecting the most
intensive washing programme and maximum temperature, at
least 65½C. Repeat the operation if necessary.
The grille should be cleaned with luke warm water and non-
abrasive detergent when you change the filter.
The grease filter can be ordered from AEG service.
Open the grille and push on the stops M to take out the filter.
See Fig. 7.

Carbon filter

The activated carbon filter should only be used if you want to use
the hood in its recirculating mode.
To do this you will need an original AEG activated carbon filter
(see special accessories).
This filter cannot be cleaned or reused.
As a general rule, the activated carbon filter should be
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

115dd

Table of Contents

Save PDF