Renault Clio Workshop Repair Manual page 29

• Pretensioners
do not trigger pretensioners which
IMPORTANT:
must be returned under warranty for a stalk pro-
blem. This makes analysis of the component im-
possible for the supplier.
Return the component in the packaging of the
new one.
Destruction of the part fitted to the vehicle
Move the vehicle outside the workshop.
Connect the destruction tool to the pretensioner
after removing the seat runner cover.
Unroll all the wire supplied with the tool so that
you are far enough away from the vehicle (ap-
proximately 10 metres) when the unit is triggered.
Connect the two feed wires on the tool to a batte-
ry.
After ensuring that no-one is near, carry out the
destruction of the pretensioner by pressing the
two push buttons on the tool at the same time.
96438S
if the unit cannot be triggered (faulty igni-
NOTE :
tion module), return the old part in the packaging
from the new replacement part to ITG (Service
0429).
Air bags and seat belt pretensioners
WIRING
Destruction of the component removed from the
vehicle
Carry out the procedure in the same way as for
the driver's air bag in the pile of old tyres (see
below).
• Driver's air bag
Destruction of the component removed from the
vehicle
Carry out the operation outside the workshop.
After connecting the corresponding wiring, place
the air bag cushion on two wooden blocks in
order to avoid damaging the connector on the
ground.
96834S
88-27
88