Completing The Parts Replacement - Lenovo ThinkCentre Edge 91 Hardware Maintenance Manual

6. Remove the screw that secures the front audio and USB assembly bracket to the chassis to remove
the bracket from the chassis.
Figure 33. Removing the front audio and USB assembly
7. Install the new front audio and USB assembly into the chassis and align the screw hole in the bracket
with the corresponding hole in the chassis.
8. Install the screw to secure the new front audio and USB assembly to the chassis.
9. Reconnect the front audio and USB assembly cables to the front audio connector and the front USB
connector on the system board. See "Locating parts on the system board" on page 77.
10. To complete the installation or replacement, go to "Completing the parts replacement" on page 104.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 43.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 76 for the locations of various
components in your computer.
2. Make sure that the cables are routed correctly. Keep cables clear of the hinges and sides of the
computer chassis to avoid interference with closing the computer cover.
3. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 80.
104
ThinkCentre Hardware Maintenance Manual