Erasing Lost Or Forgotten Passwords (Clearing Cmos); Enabling Or Disabling A Device - Lenovo ThinkCentre Edge 72 Hardware Maintenance Manual

Note: A password can be any combination of up to 64 alphabetic and numeric characters. For more
information, see "Password considerations" on page 56.

Erasing lost or forgotten passwords (clearing CMOS)

This section provides instructions on how to erase lost or forgotten passwords, such as a user password.
To erase a lost or forgotten password, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. For machine types 1577, 1579, and 1607, see "Removing the computer
cover" on page 82. For machine types 1578, 1583, and 1652, see "Removing the computer cover" on
page 116.
3. Locate the Clear CMOS /Recovery jumper on the system board. See "Locating parts on the system
board" on page 72.
4. Move the jumper from the standard position (pin 1 and pin 2) to the maintenance position (pin 2 and
pin 3).
5. Reinstall the computer cover and connect the power cord. For machine types 1577, 1579, and 1607,
see "Completing the parts replacement" on page 112. For machine types 1578, 1583, and 1652, see
"Completing the parts replacement" on page 154.
6. Turn on the computer and leave it on for approximately 10 seconds. Then, turn off the computer by
holding the power switch for approximately five seconds.
7. Repeat step 1 through step 3.
8. Move the Clear CMOS /Recovery jumper back to the standard position (pin 1 and pin 2).
9. Reinstall the computer cover and connect the power cord. For machine types 1577, 1579, and 1607,
see "Completing the parts replacement" on page 112. For machine types 1578, 1583, and 1652, see
"Completing the parts replacement" on page 154.

Enabling or disabling a device

This section provides information on how to enable or disable user access to the following devices:
USB Setup
SATA Controller
To enable or disable a device, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 55.
2. From the Setup Utility program main menu, select Devices.
3. Depending on the device you want to enable or disable, do one of the following:
• Select USB Setup to enable or disable a USB device.
• Select ATA Drives Setup ➙ SATA Controller to enable or disable a SATA device.
4. Select the desired settings and press Enter.
5. Press F10 to save and exit the Setup Utility program. See "Exiting the Setup Utility program" on page 59.
Use this option to enable or disable a USB connector. When a USB connector is
disabled, the device connected to the USB connector cannot be used.
When this feature is set to Disable, all devices connected to the SATA connectors
(such as hard disk drives or the optical drive) are disabled and cannot be accessed.
.
Chapter 6 Using the Setup Utility program
57