Setting Your Changes As A New Default; Restoring All Settings To The Factory Settings - Brother DCP-385C User Manual

Chapter 4
Using a scanned paper document as
your watermark
a
Enter the number of copies you want.
b
Press a or b to choose
Watermark Copy.
Press OK.
c
Press d or c to choose On.
d
Press a or b to choose
Current Setting.
Press OK.
e
Press a or b to choose Scan. Press OK
and set the page that you want to use as
a watermark on the scanner glass.
f
Press Mono Start or Colour Start.
g
Take out the watermark document you
scanned and load the document you
want to copy.
h
Press d or c to change the
Transparency of the watermark.
Press OK.
i
If you do not want to change any
additional settings, press Mono Start or
Colour Start.
Note
You cannot enlarge or reduce the
scanned watermark.
32
Setting your changes as a
new default
4
You can save the copy settings for Quality,
Enlarge/Reduce, Brightness,
Contrast and Page Layout that you use
most often by setting them as the default
settings. These settings will stay until you
change them again.
a
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b
After changing the last setting, press a
or b to choose Set New Default.
Press OK.
c
Press + to choose Yes.
d
Press Stop/Exit.
Restoring all settings to the
factory settings
You can restore all the settings you have
changed back to the factory settings. These
settings will stay until you change them again.
a
Press a or b to choose
Factory Reset.
Press OK.
b
Press + to choose Yes.
c
Press Stop/Exit.
4
4