Message List - Canon Satera LBP-3910 User Manual

Message List

When the printer cannot continue printing for some reason (an error status), the
printer beeps, the
indicates the description of the error appears in the display. A Warning message
appears in the display when the printer requires some remedy (a warning status)
although the job is not affected.
If either of these messages appears, perform the following procedures according to
the message.
NOTE
When multiple warnings are occurring at the same time, the Waning messages appear
•
by rotation.
When the printer is in error status and warning status at the same time, the Waning
•
message does not appear.
For a message with the <Warning Message> mark, the printer does not stop the
•
operation even when the message is being displayed (when the printer is in a warning
status).
For a message with the <Auto Error Skip> mark, you can skip the error by pressing [
•
not be printed properly. When you want to stop the process, perform a soft reset to
eliminate the cause of the error, press [
automatically skip the errors to which this mark is attached by setting <
Message
(xxx indicates abbreviations
of paper sizes)
indicator comes on, and an error message that
] and continue printing. However, part of the print data may be missing or it may
> in the menu to <
Cause
Remedy Please wait a moment. The printer cools down
Cause
Remedy Refill or load paper.
], and then print again. Also, you can
>.
Cause and Remedy
The temperature of the fixing unit exceeded a
fixed value after printing (especially paper with a
narrower width) continuously.
the fixing unit automatically. It resumes the job
after finishing the cool down process.
Paper of the size specified in the application is
not loaded in the paper source (in all the paper
sources when <
in the specified paper source when the setting is
fixed).
> is set to < >;
93