Installing Or Replacing A Pci Card - Lenovo ThinkCentre A58 Hardware Maintenance Manual

7. Position the new memory module over the memory slot. Make sure that the
Figure 10. Installing the memory module
8. Reinstall any parts and reconnect any cables that have been removed.

Installing or replacing a PCI card

This section provides instructions on how to install or replace a PCI card.
Your computer has two standard PCI card slots, one PCI Express x1 card slot, and
one PCI Express x16 graphics card slot.
To install or replace a PCI card, do the following:
1. Remove the computer cover. See "Removing the computer cover" on page 90.
2. Remove any parts and disconnect any cables that might prevent your access to
96
Hardware Maintenance Manual
notch 1 of the new memory module is aligned with the slot key 2 of the
memory slot. Then, press the new memory module straight down into the
memory slot until the retaining clips close and the new memory module snaps
into position.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the installation or replacement, go to "Completing the parts
replacement" on page 118.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
the PCI card slots.