Miele W 827 Operating Instructions Manual page 18

^ Press the I-ON/0-OFF button.
^ To continue with the same
programme press the I-ON/0-OFF
button again.
The machine will accept the following
changes after the START button has
been pressed,
– selection of a different temperature,
extra selection or de-selection of the
Water plus option can be carried out
up to 6 minutes after start.
– the spin speed for final spin can be
changed if the programme permits.
After start it is no longer possible to se-
lect a different programme.
If a different programme or 6 minutes
after start another temperature is se-
lected the indicator light Anti-crease/
Finish flashes. This does not affect the
programme sequence. The indicator
light goes out when the programme se-
lector is set back to the programme or
temperature previously chosen.
18
To select a different programme pro-
ceed as follows:
^ With the I-ON/0-OFF button switch off
the appliance.
^ Turn the programme selector to Fin-
ish .
^ Switch the machine on with the I-ON/
0-OFF button.
^ Select a new programme.
^ Press the START button.
^ Turn the programme selector to Fin-
ish .
As soon as the programme sequence
light for the stage at which the
programme should continue starts
flashing:
^ Turn the programme selector switch
to the appropriate programme within
4 seconds.
When programme locking has been
activated the programme cannot be
changed nor can a programme
stage be repeated or left out.