Paper Exit Sensor (Ps2); Discharger Brush (Discharging Brush 3) - Brother HL-3450CN Service Manual

4.4.5

Paper exit sensor (PS2)

(1) Disconnect the harness connected to the paper exit sensor.
(2) Remove the paper exit sensor from the sensor base.
NOTE:
When re-assembling the cleaning roller sensor and paper exit sensor, be sure to connect the
correct harness to either sensors as below;
N
Cleaning roller sensor harness:
N
Paper exit sensor harness:
4.4.6

Discharger brush (Discharging brush 3)

(1) Remove the fixing screws BT4x8 (2 pcs.) from the discharger brush.
(2) Remove the discharger brush.
Do not deform the discharger brush.
Discharger brush
Paper exit sensor
Fig. 7-67
Brown
Yellow
PRECAUTION
Paper exit guide
Fig. 7-68
7-45
HL-3450CN SERVICE MANUAL
Sensor base