Brother MFC6800 Service Manual page 184

Selector
No.
1
| Not used.
7
Erasure of message stored in the
8
memory after the message transfer
Selector 8: Erasure of message
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
Selector
No.
1 ECM* in sending
2 ECM* in receiving
3 Call Waiting Caller ID
4 Not used.
5
Acceptable TCF bit error rate (%)
|
(Only at 4800 bps)
8
NOTE: Selector 3 is applicable to the American version only, but not applicable to those models
equipped with high-speed modem.
NOTE: Selectors 5 through 8 are applicable to the Asian version only.
Selector 3: Call Waiting Caller ID
Setting this selector to "0" allows the user to decide whether or not to interrupt the current call
when a new call comes in. If Call Waiting Caller ID service is available in the area and the user
subscribes to it, he/she can see information about his/her incoming call.
Selectors 5 through 8:
Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you
set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.
WSW21
Function
WSW22
Function
Acceptable TCF bit error rate (%)
25
(TAD setting 1)
Setting and Specifications
0: Yes
(ECM setting)
Setting and Specifications
0: ON
0: ON
0: ON
0: 0%
0: 0%
0: 0%
0: 0%
1: No
1: OFF
1: OFF
1: OFF
1: 8%
1: 4%
1: 2%
1: 1%
* ECM: Error correction mode