Brother MFC6800 Service Manual page 116

WSW No.
WSW34
WSW35
WSW36
WSW37
WSW38
WSW39
WSW40
WSW41
WSW42
WSW43
WSW44
WSW45
WSW46
Operating Procedure
(1) Press the 1 and 0 keys in this order in the initial stage of the maintenance mode.
The machine displays the "WSW00" on the LCD and becomes ready to accept a firmware
switch number.
(2) Enter the desired number from the firmware switch numbers (01 through 46).
The following appears on the LCD:
(3) Use the right and left arrow keys to move the cursor to the selector position to be modified.
(4) Enter the desired number using the 0 and 1 keys.
(5) Press the Set key. This operation saves the newly entered selector values onto the EEPROM
and readies the machine for accepting a firmware switch number.
(6) Repeat steps (2) through (5) until the modification for the desired firmware switches is
completed.
(7) Press the Set or Stop key to return the machine to the initial stage of the maintenance mode.
NOTES: • To cancel this operation and return the machine to the initial stage of the
maintenance mode during the above procedure, press the Stop key.
• If there is a pause of more than one minute after a single-digit number is entered for
double-digit firmware switch numbers, the machine will automatically return to the
initial stage of the maintenance mode.
Details of Firmware Switches
The details of the firmware switches are described in Appendix 2 in which the user-accessible
selectors of the firmware switches are shaded.
Firmware Switches (WSW01 through WSW46) Continued
Function setting 12
Function setting 13
Function setting 14
Function setting 15
Function setting 16 in V. 34 mode
Transmission speed setting in V. 34 mode
Function setting 17 in V. 34 mode
CCD fluorescent lamp and modem attenuator in V. 34 mode
Function setting 18
Function setting 19
Speeding up scanning-1
Speeding up scanning-2
Monitor of power ON/OFF state
Selector 1
WSWXX = 0 0 0 0 0 0 0 0
Function
Selector 8
5 -1 0