4.1.17 Cover/Registration Sensor PCB, Duct, and Fan
(1) Take off the duct by removing the two screws.
(2) Unlatch the cover/registration sensor PCB and lift it up and out of the main cover.
(3) Disconnect the fan harness from the PCB.
(4) Take off the fan support by removing the screw.
(5) Lift up the fan.
Reassembling Notes
• Route the fan harness on the fan as illustrated above.
• Put the fan back into place with the label side facing outwards and with its harness directed as
shown above.
4 -3 3