Cisco Nexus 2232Tm Fex - Cisco SD2008T-NA Installation Manual

Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
Figure 2-11 on page 2-10
uplink connections. For the cable specifications that apply to these transceivers, see the
Transceiver Specifications" section on page
Figure 2-12 on page 2-11
downlink connections.

Cisco Nexus 2232TM FEX

The Cisco Nexus 2232TM FEX is a stackable, 1- and 10-Gigabit FEX that has 32 1- and 10-Gbps
Ethernet host-facing (downlink) 1/10GBASE-T ports and eight 10-Gbps Ethernet network-facing
(uplink) SFP+ ports. It requires a 19-inch (48.26 cm) rack for its installation.
characteristics.
Table 2-5
Dimensions
Weight
1. Measured with two power supplies and one fan module installed
You can order the Cisco Nexus 2232TM with front-to-back (port-side exhaust) or back-to-front
(port-side intake) airflow and with AC or DC power supplies. If you are going to install the port side in
a hot aisle, then order front-to-back airflow for the fan trays and power supplies. If you are going to
install the port side in the cold aisle, order back-to-front airflow for the fan trays and power supplies.
The front of the Cisco Nexus 2232TM FEX chassis has one or two power supplies, a fan tray, and two
LEDs as shown in
redundancy, you must install a second power supply.
OL-19013-05
identifies the major features of the SFP+ copper transceiver and cable used for
identifies the major features of RJ-45 connectors, which are used for the
Physical Characteristics for the Cisco Nexus 2232TM FEX
Width
Depth
Height
1
Figure 2-16. This FEX model requires one power supply, but if you want power
B-7.
17.3 inches (43.94 cm)
17.7 inches (44.96 cm)
1.72 inches (4.37 cm)
18.3 lb (8.3 kg)
Cisco Nexus 2000 Series Hardware Installation Guide
Cisco Nexus 2232TM FEX
"SFP+ Copper
Table 2-7 lists its physical
2-15