Electrolux 240400112 Use & Care Manual page 6

Top mount refrigerator
Table of Contents

Advertisement

Door Removal and Reversal Instructions
DOOR REMOVAL AND REVERSAL INSTRUCTIONS:
NOTE: If you have stainless steel doors -- go to the Removing Stainless
Steel Doors and Handles Section on page 9.
NOTE: The direction in which your refrigerator doors open (door swing)
can be reversed, from left to right or right to left, by moving the door
hinges from one side to the other. Reversing the door swing should be
performed by a qualified person.
IMPORTANT: Before you begin, turn the refrigerator temperature control
to "0" and remove the electrical power cord from the wall outlet. Remove
any food from door shelves.
1. Remove toe grille and top hinge cover.
2. Remove top hinge with 3/8" hex driver and lift freezer door off of
center hinge pin. Set door aside.
3. Unscrew center hinge pin using adjustable wrench and save for
reassembly. Ensure plastic washer stays on hinge pin.
4. Lift refrigerator door off of bottom hinge and set aside.
5. Remove center hinge and shim by removing inside screw and
loosening two outside screws enough to allow hinge and shim to
slide out. Tighten screws.
6. Loosen two outside screws on opposite side of refrigerator, remove
inside screw and install center hinge.
7.
Remove two screws on bottom hinge with 3/8" socket wrench.
8.
Install bottom hinge on opposite side with the two screws removed
from step 7.
9. Unscrew bottom hinge pin using adjustable wrench. Move hinge pin
to other hole in hinge and tighten with adjustable wrench.
10. Reverse door handles (see instructions on next page).
11. Move freezer and refrigerator door stops to opposite side. Before
starting screws, use an awl to puncture the foam.
12. Position refrigerator door onto bottom hinge pin and screw center
hinge pin through center hinge into top of door. Close refrigerator door
to help align hinge hole.
13. Tighten center hinge pin with adjustable wrench.
14. Remove cabinet and hinge hole plugs and move to opposite side.
15. Lower freezer door onto center hinge pin.
16. Close freezer door. Have an assistant lift up on opposite side of door
while tightening screws to install top hinge.
17. Replace toe grille and top hinge cover.
18. Plug in electrical power cord and turn refrigerator temperature control
to center position. Adjust setting as necessary.
6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

240400112en

Table of Contents