Table of Contents
Advertisement
In the case of a 2 hoop design, where one hoop is stacked
on top of the other, position the Guide Lines on the
horizontal cross line and the Center Hoop Marking on the
vertical cross line. See Fig. 5.
6. The next screen prompts you to input the first of three
alignment points, A, B, and C. These alignment points
will inform the machine exactly where the crosslines
are positioned in the hoop. It is extremely important that
the points are accurately input on the cross lines. The
machine is awaiting the input of point A. See figure 3.
Use the shift buttons on the machine to move the hoop,
until the needle comes to point A on the cross line, and
push the OK button.
MULTIPLE HOOP SHIFT BUTTONS AND “CROSS
LINE” INDICATOR LIGHTS FOR INPUTTING POINTS A,
B, AND C
Please Note: The buttons on the machine are lit
to indicate the “cross line” positions of the fabric
in the hoop. The blinking button is indicating the
point to be input.
If a mistake is made when entering the points,
press the clear button, (twin needle/clear button)
to clear the point(s). and then re-enter point(s).
Center Hoop Marking
Fig. 5
Ligne Centrale du Cerceau
Fig. 5
Marca de Centro del Aro
Fig. 5
Guide line
Guide line
Ligne Guide
Ligne Guide
Línea guía
Línea guía
Center Hoop Marking
Ligne Centrale
du Cerceau
Marca de Centro del Aro
Upward
Shift switch
Vers le haut
Commutateur de
Hacia arriba Downward
changement
Vers le bas
Interruptor de cambio
Leftward
Hacia abajo
Vers la
OK switch
gauche
Rightward
Commutateur
Hacia la
Vers la droite
d'acceptation
izquierda
Hacia la
Interruptor OK
derecha
Clear switch
Commutateur de suppression
Interruptor de borrado
A
b
C
Page 92
Hide quick links:
Advertisement
Table of Contents
