Before Attaching Embroidery Unit - Singer FUTURA XL-400 Instruction Manual

3. PREPARATION FOR EMBROIDERY SEWING

BEFORE ATTACHING EMBROIDERY UNIT

ATTACHING EMBROIDERY FOOT
Always be sure to turn off power to machine
before changing presser foot.
CAUTION
* Raise presser foot lifter.
* Turn the hand wheel counter clockwise (toward you) until
the needle is in its highest position.
1. Remove presser foot screw, presser foot and foot holder.
2. Attach the embroidery presser foot behind presser bar so
that the drive lever is above the needle clamp. Secure it by
tightening presser foot screw.
3. Turn hand wheel toward you to move needle up and down,
and check that the embroidery presser foot moves up and
down together with the needle.
Be careful not to touch the needle when
replacing presser foot.
CAUTION
INSERTING THE BOBBIN
Refer to page 14 - 15.
* A large amount of thread is required for embroidering, so
be sure to use full bobbin.
58
Foot holder
Support du pied
Sujetador prensatelas
Screw
Vis
Guia
Presser foot
Pied de biche zigzag
Pie prensatelas
Presser bar
Barre de pied presseur
Barra de prensatelas
Embroidery presser foot
Pied presseur de broderie
Prensatelas de bordado
Drive lever
Levier d'entraînement
Palanca de accionamiento
Needle clamp
Serre-aiguille
Abrazadera de aguja