The Wash Programme Stops And A Fault Indicator Light Comes On - Miele W 989i wps Operating Instructions Manual

Problem solving guide
The wash programme stops and a fault indicator light comes
on.
What to do if ...
The buzzer sounds and
the Check drain light is
flashing.
The buzzer sounds and
the Check inlet light is
flashing.
The buzzer sounds and
the Check inlet and
Check drain lights flash.
One of the following in-
dicator lights is flashing
and the buzzer is
sounding.
– "Soak/Pre-wash"
– "Main wash"
– "Rinses"
– "Rinse hold"
Three horizontal bars
"- - -" appear in the dis-
play and the buzzer is
sounding.
44
Possible cause
The water outlet is
blocked.
The drain hose has
been fixed too high.
The water inlet is
blocked
The Waterproof system
has reacted.
There is a fault.
There is a fault.
Remedy
Clean the fluff (drain) filter
and drain pump.
The maximum drain height
is 1 m.
– Open the stopcock.
– Start the programme
again.
Call the Service Depart-
ment.
– Start the programme
again.
– If the check lights flash
again, contact the Service
Department.
– Start the programme
again.
– If the three horizontal bars
"- - -" appear again, call
the Service Department.