Fixed Code Programming - Mazda Tribute Owner's Manual

2010
Hide thumbs Also See for Tribute:
Table of Contents

Advertisement

Driver Controls
The indicator light above the selected button will turn on to confirm that
the Car2U system is responding to the button command.
To program another rolling code device such as an additional garage door
opener, a security device or home lighting, repeat Steps 1 through 4
substituting a different function button in Step 3 than what you used for
the garage door opener. For example, you could assign the left-most
button to the garage door, the center button to a security device, and
the right-most button to another garage door opener.
Note: The Car2U system allows for three devices to be programmed. If
you need to change or replace any of the three devices after it has been
initially programmed, it is necessary to erase the current settings using
the Erasing the Car2U Home Automation System buttons procedure
and then programming all of the devices being used.

Fixed code programming

Note: Do not program the Car2U system with the vehicle in the garage.
Make sure that your key is on and engine off while programming the
transmitter.
1. To program units with fixed code DIP switches, you will need the
garage door hand-held transmitter, paper and a pen or pencil.
2. Open the battery cover and record the switch settings from left to
right for all 8 to 12 switches. Use the figure below:
When a switch is in the up, on, or + position, circle "L."
When a switch is in the middle, neutral, or 0 position, circle "M."
When a switch is in the down, off, or – position, circle "R."
69

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

2010 tribute

Table of Contents