Appendix A Factory Settings And Technical Specifications; Factory Settings - NETGEAR WNCE2001 - Ethernet to Wireless Adapter Workshop Manual

Factory Settings and Technical
A.
Specifications

Factory Settings

You can use the Reset button on the rear panel to return your adapter to its factory settings.
Reset
button
Figure 6. The Reset button restores factory settings
Use a pin or paperclip to press the Reset button and hold it for 5 seconds until the power
LED blinks amber.
Table 4.
Factory Settings
Smart Wizard
Wireless Wireless communication
Wireless Network Name (SSID)
Security
Transmission speed
Country/Region
Operating mode
Data rate
1 Maximum wireless signal rate (IEEE Standard 802.11). Actual throughput will vary. Network conditions and
environmental factors, including volume of network traffic, building materials and construction, and network
overhead, lower actual data throughput rate
Enabled
Disabled
Any (will connect to the first wireless network that responds)
Disabled
1
Auto
United States (varies by region)
802.11n, 802.11g, 802.11b
Up to 300 Mbps
Appendix A. Factory Settings and Technical Specifications
A
| 20