Section 7 - Advanced Setup
Enable Wireless:
If you would like to make wireless available, you must check this box
first.
Wireless Network
The SSID (Service Set Identification) is the unique name shared among
Name (SSID):
all devices in a wireless network. The SSID must be identical for all
devices in the wireless network.
Country:
The channel will adjust according to nations to adapt to each nation's
frequency provision.
Wireless Channel:
Auto setting can be selected to allow the device to choose the channel
with the least amount of interference.
802.11 Mode:
Select one of the following:
802.11g Only – Select if all of your wireless clients are 802.11g.
Mixed 802.11g and 802.11b – Select if you are using both 802.11g
and 802.11b wireless clients.
802.11b Only – Select if all of your wireless clients are 802.11b.
802.11n Only – Select if all of your wireless clients are 802.11n.
Mixed 802.11n, 802.11b, and 802.11g – Select if you are using a mix
of 802.11n, 11g, and 11b wireless clients.
Bandwidth:
Select the channel width:
Auto 20/40 – Select if you are using both 802.11n and non-802.11n
wireless devices.
20MHz – Select if you are not using any 802.11n wireless clients. This
is the default setting.
D-Link DSL-2740B ADSL2+ Modem with Wireless N 300 Router
Manual Wireless Setup
40