Reference Guide; Parameter Guide; About This Chapter; Program Parameters - Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual

Parameter Guide

About this chapter

The following chart shows how the explanations in this chapter are organized.
Related LCD screen group
0A–0B Global Oscillator Setup
These parameters are used to set the type of Program.
00A OSC Mode
DOUBLE
0A
LCD Parameter
Oscillator Mode
00A
(OSC Mode)
Assign (ASN)
00B
Hold (HLD)
LCD screen or function
button numbers.
MIDI Data Values
In general, decimal values are used throughout this Owner's Manual. Numbers that are enclosed
by square brackets are hexadecimal.
• The words "keyboard" and "joystick" used in this parameter guide refer to the keyboard and
joystick on a synthesizer (such as the X3) connected to the MIDI IN terminal of the X5DR.
You can send various MIDI messages to the X5DR using the keyboard and joystick. You can
also obtain the same result by sending MIDI messages from a computer connected to the MIDI
IN or TO HOST of the X5DR.

Reference Guide

Section summary
Section title
ø
ø 00B OSC1
ASN:POLY HLD:OFF
0B
Range
SINGLE
DOUBLE
DRUMS
POLY
MONO
ON/OFF
Parameters on each Parameter range or
LCD screen available settings
The characters in The left-most value or
parentheses( ) are the value on the upper
shown on the screen. line is obtained when
you press and hold
down the [ ] button.
LCD screens in the group
Press the [ ], [®] cursor
buttons to move to the
previous and next
screens, respectively.
Description
Oscillator 1
Oscillator1 and Oscillator2
A drum kit
Polyphonic
Monophonic
Note hold after key release (set to ON for DRUMS mode)
Brief description. A full
description is provided
in the text below each
parameter table.
Reference Guide
1
Program
Parameters
77