Using a Computer/Sequencer
Connecting the power
Connect the AC adapter plug
to the DC IN connector on the
rear panel, and plug the AC
adapter into an AC outlet.
To the power outlet
IBM PC compatible
Connecting the computer/sequencer
There are two methods to connect your computer or
sequencer to the X5DR: "Connection via MIDI" and
"Computer interface cable." Refer to page 10–13 for details.
Powered monitor/stereo amplifier
In order to play back the X5DR's high-fidelity sound, we recommend that you connect the X5DR to
powered monitors (speakers with built-in amplifiers, such as the optional PM-15). If you are going to
connect an audio stereo amplifier or other device (such as a stereo radio or a cassette tape recorder),
use the connector labeled "LINE IN" or "AUX IN" on those devices.
If you connect the X5DR to a domestic hi-fi system, be careful not to raise the volume level too
high or you may damage the speakers.
Secure the AC adapter
cable by hooking it as
shown in the illustration
to prevent the adapter
plug from being
DC IN 12V
Computer interface cable
To use the headphones, plug the
headphone cable into the PHONES jack
on the front panel.
Connecting the monitor
Connect the OUTPUT jacks @
to the powered monitor or
* Use the L/MONO jack for
(such as the PM-15)